SL81-000
Note: Print this MSDS | Email this Page | Back to Previous Page | Close Window
Benz Compressed Air Systems Inc
Visitors Address: 1530 Date St · Montebello CA 90640-6325 USA
Mailing Address: PO Box 729 · Montebello CA 90640-0729 USA
Tel: 323-722-6603 · 800-698-4247 · Fax: 323-887-7145
Email: info@selectlubricants.com · Web: www.selectlubricants.com
Date: 2002-12-01 - Revised: 1998-10-01 - Supersedes: 1998-02-14
I. Product Identification
Trade Name: SL81-000
Chief Constituent: Complexing agents
Hazardous Ingredients/OSHA: None
Carcinogenic Ingredients/OSHA/NTP/IARC: None
Ingredients Regulated by SARA Title 3, Section 313: None
II. Warning Statements
None
III. Physical and Chemical Data
Appearance and Odor: Blue green with mild odor
Specific Gravity: 1.06
Boiling Point: 214°F
Freezing Point: 15°F
Vapor Pressure: N/A
IV. Fire Protection
Flash Point: None
Extinguishing Media: Will not burn
Special Firefighting Procedure: None
Unusual Fire Hazard: None
V. Reactivity Data
Thermal Stability: Stable
Materials to Avoid: Strong oxidizers
Hazardous Polymerization: Will not occur
Hazardous Decomposition Products: None
VI. Health Hazard Data
Exposure Limits: Not established
Effects of Overexposure: No acute adverse affects known
VII. Physiological Effects Summary
Acute:
Eyes: Slight transient irritation. No corneal injury likely
Skin: Prolonged contact may cause slight irritation
Respiratory System: Considered to be low in hazard
Chronic: N/A
Other: N/A
VIII. Precautions for Safe Handling
For general personal hygiene, wash hands thoroughly after handling material. Avoid contact with skin and eyes.
IX. Protection and Control Messages
Protective Equipment: Safety glasses with side shields
Respiratory Protection: None required
Ventilation: Consistent with safe and normal operating procedures.
X. Emergency and First Aid Procedures
Eye Contact: Flush eyes with water for 15 minutes. If irritation develops, call physician.
Skin Contact: Wash skin with soap and water. Wash clothes before reuse.
Inhalation: Remove to fresh air.
Ingestion: Low in toxicity. Induce vomiting if large amounts ingested.
XI. Notes
Hazard Rating Information
Key: 0 = Minimal, 1 = Slight, 2 = Moderate, 3 = Serious, 4 = Severe
| Hazard | NPCA/HMIS | NFPA |
| Health Flammability Reactivity |
1 1 0 |
1 1 0 |
XII. Spill and Disposal Procedures
Environmental Impact: Report spills as required to appropriate authorities. U. S. Coast Guard regulations require immediate reporting of spills that could reach any waterway including intermittent dry creeks. Report spill to Coast Guard Toll Free Number 800-424-8802. In case of accident or road spill, notify Chemtrec 800-424-9300.
Procedures if Material is Released or Spilled: Absorb on fire retardant treated sawdust, diatomaceous earth, etc. Shovel up and dispose of at an appropriate waste disposal facility in accordance with current applicable laws and regulations, and product characteristics at time of disposal.
Waste Management: Dispose of according to Federal, State and Local regulations. Toxic Substance Inventory Control Act: All components are included on the TSCA Inventory and are in compliance with the TSCA.
For additional information contact:
Benz Compressed Air Systems Inc
Visitors Address: 1530 Date St · Montebello CA 90640-6325 USA
Mailing Address: PO Box 729 · Montebello CA 90640-0729 USA
Tel: 323-722-6603 · 800-698-4247 · Fax: 323-887-7145
Email: info@selectlubricants.com · Web: www.selectlubricants.com
Note: Information given herein is offered in good faith as accurate, but without guarantee. Conditions of use and suitability of the product for particular uses are beyond our control. All risks of use of the product are therefore assumed by the user and we expressly disclaim all warranties of every kind and nature, including warranties of merchantability and fitness for a particular purpose in respect to the use or suitability of the product. Nothing is intended as a recommendation for uses which infringe valid patents or as extending license under valid patents. Appropriate warnings and safe handling procedures should be provided to handlers and users.